grooveloom

How to morph between two versions of a pad on the PolyBrute

The questionhow do i set up the morph knob to blend between two versions of my pad

Every PolyBrute patch is two sounds, A and B, and the Morph knob moves between them. To blend two versions of one pad, start B as a copy of A, change B, then sweep.

40 seconds, no voice. The captions carry every step. The sound follows each move; it isn't recorded from a PolyBrute.
The short answer

Every patch holds two sounds, A and B. Morph moves between them.

Before you start

Have your pad playing with Morph all the way at A.

Four steps

  1. Press Morph and pick Copy A->B. Now B starts as your pad too.

    0:08

  2. Turn Morph all the way to B and open the Ladder Cutoff. Only B changes.

    0:14

  3. Sweep Morph back and forth. The sound glides between the two.

    0:21

  4. Park it where it sounds best, then press Save three times. Its position is stored with the patch.

    0:27

Two versions. One knob.

Good to know

With Morph fully at A, the sound's knobs and sliders change A only. Fully at B, they change B only. In between, they change both. Pressing Save three times saves over the patch you started from.

More PolyBrute guides